Powered
paragliding Ontario PPG NEWS
(for
most recent news see scroller at the home
page)
__________________________________________________________________
July 20/02 Dear Pilots:
Due to a couple of economic factors, our products have substantially
risen in value. These factors are as follows:
1. Due to the booming Czech economy the Czech
Crown is advancing against EURO dollar and Euro dollar is advancing against
USD. This change representing more then 30% increase in trade deficit.
2. Due to the sky-rocketing popularity and recognition the units have attained a high profile status,
internationally, as well as domestically.
Effective immediately, the MSRP has been adjusted accordingly.
At the current price structure, WJ units reflect the value in
superior cage/frame design, flight comfort and leading edge
innovation.
July 16/02
Well, some of you may wonder what is going
on. The page is not being updated.... It is simply because I totally
lack time. My other business (the climbing gym) is still unusually
busy and there is a quite few people who are willing to learn how to
fly PPG therefore I have to leave all the less important tasks for
later. For those who are in training note that I will be out of
country July 15 - 18 and July 23 to Aug 15/05. If you have to get
hold of me you can do so by email.
June 2/02
Folks,
We used 92 octane pump
gas and Mogul 100% synthetic oil mixed 1:40.
I'm exited about this, because Demo Days is the largest gathering of
PG equipment and pilots in the USA and it is on the 17-19 of this
month. I hope that we get many manufacturers to show up. I will
conduct our own home brewed test here. All machines willing to
participate will get to drink from the same gas tank, mixed to
whatever ratio they desire with their own oil.
There are a lot of tricks that manufacturers can do to increase
static thrust.
1. Increase the reduction ratio, and let the Simonini mini 2 plus
run at over 8,000 rpm thus turning the prop much faster
2. mix in avgas with regular gas and pour in some lead for good
measure
3. use a HUGE needle in a Bing carburetor and let the motor drink
like a garden hose.
As you can see, such a motor can be capable of turning out over
200lb of thrust but it will last about 1 day. We use stock Simonini with stock components and the net result is that our motors last. We
do not over stress them, and our props have a much better dynamic thrust
test than static.
As well as the thrust test, we will conduct highest altitude gain
test. Needless to say, I am exited about our new chromed mufflers.
If you are looking for an upgrade, please send me an e-mail.
If you can make it out to Demo Days, please send me an e-mail.
The trip is worth while. Stunning scenery, snow covered mountains
and good folks to hang out with. We will have our new Simon RR and
Spider RR on display.
By Milos at Walkerjet.com
April 17/02Para stars Report - Thrust
Tests By Milos Krivka
Dave Beresh of Beresh Props did a solid and un-reputable monitor
of the thrust test so that he could observe the performance of
his props.
Once again, we have beat all but the Monster, which weighs
considerably more and has 150cc advantage. With our new tuned
exhaust, generation 5, that produces 8 more lb, we will clean up
quite nicely ! Scoot Cruise had the gen. 4 exhaust and a
Wallbro, that produces less thrust, so conceivably, we would
have won again, had we introduced gen. 5 muffler earlier in the
season. Last year, we have beat the Monster by 1 lb with a
smaller prop, just goes to show how temperature and humidity can
affect the results. Demo Days in Utah will prove to be the
tie-breaker.
Thanks to Dave Beresh, we have a reliable and un-tainted
results. Dave Beresh is the manufacturer of some of the best PPG
props in the world. Contrary to some unofficial mumbo jumbo -
nobody got 160lb thrust test. Nobody! The humidity and high
density altitude pretty much pegged everyone.
April 11/02. I took the Simon XC for a couple of
short flights as to brake it in. It was sitting in my shop for 3 months so I was wondering what is going to take to get it
started. I have mixed the fuel (30:1) poured it in, pushed the
start button and.... the thing just started to run. I could not believe
it. It was so easy. I have wormed it up, tuned it and took off. The Simon
has more power then Superhawk as I was climbing at approximately
340 ft min. I have tried to turn the motor off and re-started in
flight many times and it would always kick in no problem. It was
very nice to be able to soar in the thermals and all you can
hear is the sound of wind.... If you lose it though, just one
push of the start button will get you back up and you can try
again. I will have to get my self a variometer as I discovered
a new dimension of free flying. It takes quite skill to be able
to stay up just using the thermals - especially without the
variometer. I have landed after about 30 min and re-checked the
spark plug. It was a little oily as I was running on the rich
side. I have adjusted the high carb screw and took off for
another awesome flight. After carb adjustment the Simon XC had
even more power and there was almost no vibration at all. I love
this machine. I soon as I sell my Superhawk I am getting one of
these....
March 29/02. Well, today I had a first flight of
the season. The weather was not the best, the field was little
muddy but I could not wait any more. I took off and flew south
bound for about 45 min. The wind was high at 20 km/h gusting to
25 km/h. Approximately 12 km from the fields I could feel a
light precipitation and decided to turn around. It took me
only 10 min to get back as I was flying at close to 60 km/h. The
wind got actually even stronger so I had to use full speed bar
to make it to the lending zone. By the time I got packed it was
dripping. I dropped off a bottle of Cognac to the owner of the
field Joe Zawadski as a token of appreciation for letting me use
his property.
Brontes - whose name comes from Greek word for thunder
- successfully passed the load test and now is flight-tested in its
middle size (BRONTES M). The first reactions of test pilots are very
positive, claiming that the glider is very “easy to handle”, has
got “excellent flying stability”, “smooth reactions and still,
plenty of performance which might be used not only for conventional
and occasional flying but also for acrobatics”.And still being mainly DHV 1-2 and 2 rated wing in most
flight test regimes. At the moment the test pilots examine the possibility
of further development of the glider for the acrobatics enthusiasts
and we will keep you updated about further development.
We all hope that Brontes will be soon “thundering”
all over mountain slopes and will met arm reaction of our customers.
Oct 28/01 Models 2002 released.
1. All
bolts are drilled and safety wired
2. Most components are drilled
for lightness
3. Wiring harness is completely enclosed for weather
protection
4. Hand throttle has built in starter cut-off, instead of
it being on the frame.
5. Comfort bar pegs are welded in instead of
riveted
6. Harness is a Sup-Air - more room and comfort for the big
pilots
7. Top motor bolt in has 2 silent blocks instead of one.
8.
New filter - more breathing room, more power
9. Head has much better
casting process - smoother look and larger anodized head for better
cooling and look
10. Muffler is smaller and lighter
11. All models
have external charger port in case pilot drains the battery.
The
Simon models are perfect for the demanding PPG pilot who needs
power, quality, reliability and value.